ProForm 831.23745.1 user manual Assembly

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included hex keys, assembly requires a Phillips screwdriver , an adjustable

wrench , and a rubber mallet .

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. IMPORTANT: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled. If a part is missing, call 1-888-533-1333.

M8 Nylon		M6 Split	M10 Spacer			M10 Split	Wave Washer
Locknut (96)–4		Washer (88)–8			(76)–2	Washer (72)–2	(93)–6
M4 x 16mm	M4 x 16mm		M4 x 16mm		M4 x 12mm
Screw (86)–4	Self-tapping		Flange Screw		Flange Screw
	Screw (79)–10		(84)–2		(73)–6
						M10 x 20mm x	M10 x 25mm x
	M4 x 65mm Screw (91)–4					2mm Washer	1.5mm Washer
						(81)–2	(83)–10
M6 x 16mm Phillips		M8 x 16mm Patch		M8 x 42mm Button Bolt (71)–4			M10 x 23mm Shoulder
Patch Screw (87)–8		Screw (95)–3					Patch Screw (80)–2
M10 x 15mm Patch		M10 x 48mm Patch Screw (78)–2				M10 x 62mm Patch Bolt (97)–2
Screw (82)–10
			M10 x 35mm Shoulder
			Patch Screw (94)–2
					5