3.Attach the Latch Assembly (82) to the Left Upright (84) with the two Latch Screws (134). Start both Latch Screws before tightening either of them. Note: The Latch Screws may be preattached to the Left Upright.
4.Refer to step 6 and locate the four Upright Bolts (86). Loosen the Upright Bolts two to three turns.
Refer to drawing 4c. With the help of a second person, hold the Console Base (101) near the Uprights (80, 84). Look under the Console Base and locate the wires on the sides of the Console Base. Make sure that the wires are not routed through the openings for the Trays (109, 111). Drawing 4a shows the correct route for the wires. Drawing 4b shows an incorrect route.
Refer to drawing 4c. Cut the plastic ties holding the Wire Harness (74) and the Pulse Wire (70) in the Uprights (80, 84). Connect the Wire Harness and the Pulse Wire to the wires on the sides of the Console Base (101). Make sure to connect the connectors properly (see the inset drawings). IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM- AGED WHEN THE POWER IS TURNED ON. The con- nectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. Insert the excess Wire Harness and Pulse Wire up into the Console Base.
Press the Right and Left Top Endcaps (75, 81) into the Uprights (80, 84) as shown.
5.Set the Console Base (101) on the Uprights (80, 84). Be careful not to pinch the Wires (not shown) in the Uprights. Attach the Console Base to each Upright with two Console Bolts (76) and two Internal Star Washers (77); start all four Console Bolts before tightening any of them.
Make sure that the Left and Right Trays (109, 111) are pressed into the Console Base (101).
3 |
|
|
| 134 | 82 |
|
| |
| 84 |
|
4a |
| 4b |
| Correct | Incorrect |
4c |
|
|
| 111 | 109 |
|
| |
| 101 | 81 |
| 75 |
|
| 80 | 84 |
| 74 | 70 |
|
| |
5 |
| 101 |
|
| 84 |
| 111 | 109 |
| 77 | 77 |
|
| |
|
| 77 |
76 | 80 | 76 |
6
