ProForm 831.29606.0 user manual Bolts yet, Firmly tighten the two 1 3/4 Bolts

2.Slide the left Handrail (43) onto the post on the left Upright (97) and onto the left Handrail Bracket (81). Finger tighten two Handrail Bolts (80) into the left Handrail and the post; do not fully tighten the Handrail

Bolts yet.

Set the Handrail Cap (105) against the left Upright (97). Tighten a Screw (95) into the bottom of the Handrail Cover and into the left Handrail Bracket (81). Then, tighten the two Handrail Bolts (80).

Slide the Left Handrail Cover (27) against the Console Base (101). Tighten two Cover Screws (34) into the Left Handrail Cover and the left Upright (97); be careful not to overtighten the Cover Screws.

Repeat steps 1 and 2 on the right side (not shown).

3.Remove the knob from the pin. Make sure that the collar and the spring are on the pin. Next, insert the pin into the Left Handrail Cover (27), and tighten the knob back onto the pin.

Place the treadmill in the storage position (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 21).

4Orient the U-base (89) so the Base Pads (99) are un- derneath it, and position the U-base against the base of the Uprights (97) as shown. Insert two 1 3/4” Bolts (76) with Washers (71) into the base of the Uprights and the U-base; if necessary, tip the Uprights forward as you in- sert the Bolts. Finger tighten the Bolts.

Next, insert two 3” Bolts (86) into the U-base (89) and the base of the Uprights (97); if necessary, tip the Uprights forward as you insert the Bolts. Finger tighten two Nuts (20) with Washers (71) onto the Bolts.

Firmly tighten the two 1 3/4” Bolts (76).

2		80
			Post
		27
	43
			101
		34	97
		105
			81
		95
3
Knob
		27
		Spring
			Collar
			Pin
4		59
			97
		76
		71
89
		20
99	86
		71
		86
		71	20

6