1Insert the key fully into the power switch.

Inserting the key will not turn on the dis- plays. The displays will

turn on when the ON/RESET button is

pressed or when the walking belt is started. Note: If you just

installed batteries, the displays will already be on.

2Reset the speed control.

Slide the speed control down to the RESET position. Note: Each time the walking belt is stopped, the speed control must be moved to the RESET position before the walking belt can be restarted.

3Start the walking belt.

After you have moved the speed control to the RESET position, slowly slide it upward until the walking belt begins to move at slow speed.

Carefully step onto the walking belt and begin ex- ercising. Change the speed of the walking belt as desired by sliding the speed control.

To stop the walking belt, step onto the foot rails and slide the speed control to the RESET position.

4Adjust the incline of the treadmill as desired.

To change the incline of the treadmill, press the top or bottom of the in- cline control until the desired incline level is reached.

5Follow your progress with the LED track and the four displays.

The LED TrackÑThe track in the center of the console represent a distance of 1/4 mile. As you exercise, the indi- cators around the track will light one at a time

until you have completed 1/4 mile. A new lap will then begin.

SPEED displayÑThis display shows the speed of the walking belt, in miles per hour.

TIME displayÑThis display shows the elapsed time.

DISTANCE displayÑ This display shows the distance that you have walked or run, in miles.

CALS/FAT CALS

 

 

 

 

 

 

 

Arrow

 

 

displayÑThis display

 

 

 

 

 

 

 

 

 

shows the approximate

 

 

 

 

 

numbers of calories

 

 

 

 

 

and fat calories you

 

 

 

 

 

have burned. (See FAT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

BURNING on page 14.)

 

 

 

 

 

Every seven seconds, the display will change from one number to the other. Arrows in the display will indicate which number is currently shown.

To reset the displays at any time, press the ON/RESET button.

6When you are finished exercising, stop the walking belt and remove the key.

Step onto the foot rails, stop the walking belt and remove the key from the console. The displays will turn off about five minutes after the key is removed.

Note: To conserve the batteries, the displays will automatically turn off any time that the walking belt is stopped and the ON/RESET button is not pressed for five minutes.

9

Page 9
Image 9
ProForm 831.29721 user manual Insert the key fully into the power switch, Reset the speed control, Start the walking belt