3.Hold the Right Handrail (7) at an angle as shown and in- sert the upper end into the Right Upright (11). Keep the lower end of the Handrail away from the treadmill to avoid scratching the finish. Next, rotate the lower end of the Handrail to the position shown by the dotted line.
Make sure that the hole in the lower end of the Right Handrail (7) is aligned with the hole in the Extension Leg (34). If the holes are not aligned, rotate the Handrail away from the treadmill and pull the upper end of the Handrail out of the Upright (11) slightly. Then, rotate the Handrail back to the position shown by the dotted line. Repeat until the holes are aligned.
4.Attach the Right Handrail (7) to the Extension Leg (34) with a Handrail Bolt (90), a Handrail Washer (92) and a Handrail Nut (91).
Repeat steps 3 and 4 to attach the Left Handrail (not shown).
5.Attach the Storage Latch (14) to the left Upright (11) with two Latch Screws (35). Be careful not to overtighten the Latch Screws.
6.Remove the backing from the Adhesive Clip (33). Press the Adhesive Clip onto the right Upright (11) in the indi- cated location. Press the Allen Wrench (88) into the Adhesive Clip.
7.Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill.
3
11
7
34
4
7
34
91 92 90
5
35
11
14
6
11
88
33
6
