DIAGRAM OF THE CONSOLE
Monitor Displays | Incline Control |
Speed Control Clip
Key | Note: If there is a thin sheet of clear |
plastic on the console, remove it. | |
|
|
CAUTION: Before operating the con- sole, read the following precautions.
•Do not stand on the walking belt when turning on the power.
•Always wear the clip (see the drawing above) while operating the treadmill. When the key is removed from the console, the walking belt will stop.
BATTERY INSTALLATION
The console | Battery Cover |
requires two or | |
three "AA" bat- |
|
teries (not in- |
|
cluded). Alkaline |
|
batteries are rec- |
|
ommended. To |
|
install batteries, |
|
open the battery |
|
cover as shown. | Batteries |
Press the batter- |
|
ies into the battery |
|
compartment, with the negative ends of the batteries (marked
•Adjust the speed in small increments.
•The training zones marked beside the speed control are general guidelines only. See pages 14 and 15 for more information.
•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console. Use only a sealable water bottle.
STEP BY STEP CONSOLE OPERATION
Step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing. Follow the steps below and on page 9 to operate the console.
1 Insert the key fully into the power switch.
The four displays will
not turn on until the ON/RESET button is
pressed or the walk-
ing belt is started. Note: If you just in-
stalled batteries, the displays will already be on.
8
