ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver 
, adjustable wrench 
and scissors 
.
1.With the help of a second person, carefully raise the treadmill to the upright position. While the other person tips the treadmill to one side and holds it, insert one of the Extension Legs (103) into the treadmill. Make sure that the Extension Leg is turned so the Warning Decal
(20)is on top. Tighten two of the four Short Screws
(101)into the treadmill and the Extension Leg.
Next, tip the treadmill to the other side and attach the other Extension Leg (not shown) in the same way. Lower the side of the treadmill so that both Extension Legs
(103)are resting flat on the floor.
2.Refer to HOW TO LOWER THE TREADMILL FOR USE on page 11. Follow the instructions in step 2 to lower the treadmill.
Without removing the tape from the Latch (77), attach the Latch to the left Upright (82) with two 3/4Ó Screws
(81).Make sure that the Screws are tight, but do not overtighten them; if the Screws are overtightened, the Latch will not slide smoothly. After the Latch is attached, remove any visible tape.
Note: The inset drawing shows how the parts of the Latch (77) fit together.
3.Cut the plastic tie off the bracket on the base of each Upright (82).
Next, cut the plastic tie off the Left Handrail (74). Position the Left Handrail on the left Upright (82). The bracket on the base of the left Upright should be inside of the lower end of the Left Handrail, as shown in the inset drawing.
1 |
|
20 |
|
103 | 101 |
| |
2 |
|
82 |
|
77 | Spacer |
81 |
|
| Springs |
| Latch |
| Bracket |
3 |
|
74 |
|
Plastic |
|
Tie |
|
82 | 82 |
| |
| Plastic |
| Tie |
| 74 |
| Bracket |
5
