4.Make sure that the front edge of the Right Foam Grip (75) is under the Console Base (81) as shown. Tighten a 3/4” Screw (100) into the side of the Right Foam Grip as shown. Note: It may be necessary to pull the Foam Grip outward slightly (see arrow A) to align the Screw with the hole in the post.
Attach the other Handrail Extension (not shown) and the Left Foam Grip (not shown) as described in step 3 and this step.
5.Press the Lock Knob Sleeve (70) into the left Upright (69).
Remove the Lock Knob (68) from the Lock Pin (74). Make sure that the two Lock Pin Collars (72) and the Spring (71) are on the Lock Pin. Insert the Lock Pin into the Lock Knob Sleeve (70) and the left Upright (69). Tighten the Lock Knob onto the Lock Pin.
6.Clean the Book Rack (124) with a clean cloth and rubbing alcohol.
Remove the paper from the top of the Book Rack Tape
(123).Make sure that the straight edge of the Book Rack
(124)is pressed against the plastic around the Console
(82).Press on the top of the Book Rack and the bottom of the Console Base (81). Wait for 24 hours before setting a book on the Book Rack.
7.Look at the Endcap (58). If the left or right foot on the End- cap does not touch the floor, the included thick base pads should be attached to the treadmill as described below.
See assembly step 2. Lower the treadmill frame and the Uprights (69) as shown. If the left foot of the Endcap (58) was off the ground, remove the two Base Pads (99) from the right Upright (69). Attach the included thick base pads to the right Upright. If the right side of the Endcap was off the ground, attach the thick base pads to the left Upright.
If either side of the Endcap (58) lifts off the floor when the treadmill is used, attach the thick base pads as described.
4 |
|
|
|
|
|
|
| A | 81 |
|
|
|
| |
|
|
|
| 100 |
|
|
| 75 |
|
5 |
|
|
|
|
|
|
| 69 |
|
| 68 |
| 70 |
|
|
| 72 |
| |
|
|
|
| |
|
|
| 74 |
|
|
|
| 71 |
|
6 |
| 124 |
|
|
|
|
|
| |
|
|
| Edge |
|
|
|
| 123 |
|
|
|
| 123 |
|
|
| 82 |
| 81 |
|
|
|
| |
7 |
|
|
|
|
| Foot |
|
|
|
|
| 58 |
|
|
|
|
| Foot |
|
8.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet from damage, place a mat under the treadmill.
7
