Grizzly G0461, G0460 owner manual Extension Tables, Components and Hardware Needed Qty

Extension Tables

Components and Hardware Needed:	Qty
Large Extension Wing	1
Small Extension Wing w/Set Screws	1
Support Leg w/Hex Bolt & Nut	1
Cap Screws M8-1.25 x 25
(Small Wing/Table)	2
Lock Washers 8mm (Small Wing/Table)	2
Flat Washers 8mm (Small Wing/Table)	2
Cap Screws M8-1.25 x 25
(Large Wing/Table)	2
Lock Washers 8mm (Large Wing/Table)	2
Flat Washers 8mm (Large Wing/Table)	2
Hex Bolt M10-1.5 x 45 (Leg/Large Wing)	1
Lock Washer 10mm (Leg/Large Wing)	1
Flat Washer 10mm (Leg/Large Wing)	1
To install the extension tables:

1.Make sure the set screws in the small exten- sion wing do not stick out from the mating surface.

2.Attach the small extension wing with two M8- 1.25 x 25 cap screws, lock washers, and flat washers as shown in Figure 20.

Note: Get assistance positioning the tables and holding them in place while installing.

Mounting Screws

Set Screws

Figure 20. Small extension wing attached.

3.Attach the large extension wing to the back of the machine with the two M8-1.25 x 25 cap screws, lock washers, and flat washers.

G0460/G0461 12" Sliding Table Saw

4.Attach the support leg (Figure 21) to the large extension wing with the M10-1.5 x 45 hex bolt, lock washer, and flat washer.

Figure 21. Support leg installed.

5.Check the table surfaces with a straightedge, as shown in Figure 22, to ensure that they are flush and even with each other.

Figure 22. Checking with a straightedge.

6.Adjust the set screws under the small exten- sion wing to align it with the main table sur- face. (You may need to slightly loosen the wing mounting cap screws to adjust the wing position.)

7.Use the hex bolt in the bottom of the support leg to level the surface of the large extension wing.

8.Tighten all of the wing mounting cap screws.

-21-