Grizzly G0460, G0461 owner manual Lubrication, See Figure

Lubrication		with an automotive wheel bearing grease
	•	Blade height and tilt worm gears. Lubricate
		(see Figure 75).
The bearings are sealed and pre-lubricated and
require no lubrication during their usable life.
However, your saw components will operate
at their best if the bearing surfaces are kept
			Blade Height
clean—this is especially important for the trunnion			Worm Gear
bearings.
Lubricate the areas indicated below every 6-12
months, depending on frequency of use.

•Sliding table ways. Spray or wipe on a light machine oil or lubricant (such as Boeshield T9®) along the entire length of the steel rods

(see Figure 74).
	Blade Tilt
	Worm Gear

Figure 75. Gear lubrication.

• Other pivot points. All other pivot points under the table should be lubricated with 6 or 7 drops of light machine oil.

Figure 74. Sliding table ways.

-42- G0460/G0461 12" Sliding Table Saw