ProForm DTL33940 user manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches		and your own phillips screwdriver		,
rubber mallet	, wire cutters	, and needlenose pliers	.

For help identifying the assembly hardware, see the drawings below. If a part is not in the parts bag, first

check to see if it has been pre-assembled.

1/2” Silver Screw	1/2” Ground Screw		3/4” Tek Screw (58)–8		3/4” Screw (2)–12
(48)–1	(75)–1
3/4” Bolt (37)–6		Washer (38)–6		Wheel Nut (32)–2
	3 1/2” Bolt (64)–2

1.Make sure that the power cord is unplugged.

With the help of another person, carefully raise the Uprights (69) to the vertical position. Insert one of the Extension Legs (63) into the treadmill as shown. (Note: It may be helpful to tip the Uprights as you insert the Extension Leg.) Make sure that the Warning Decal (62) is in the position shown.

1

69

62

63

Insert the other Extension Leg (63) in the same way.

6