ProForm DTL33940 user manual

5.Attach the end of the ground wire to the small hole in the side of the Right Handrail (72) with a Silver Ground Screw (75).

6.Loosen the two Crossbar Screws (39) two turns (only one Crossbar Screw is shown). Place the Console Base

(47)on the Right Handrail (72) and the Left Handrail (not shown). Attach the Console Base with four 3/4” Screws

(2)(only two Screws are shown). Do not overtighten the Screws.

Insert the Wire Harness (42) through the two indicated plastic ties on the Console Base (47). Next, touch the Right Handrail (72) to discharge any static. See the inset drawing. Find the 5-pin connector on the end of the Wire Harness. Insert the connector into the red socket be- neath the console. The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connec- tor and then insert it. Insert the 6-pin connector into the black socket beneath the console in the same way.

Make sure that the connectors and wires appear as shown in the inset drawing. IF THE CONNECTORS ARE

NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.

7.Insert the excess Wire Harness (42) into the large hole in the side of the Right Handrail (72). Securely tighten the plastic ties on the bottom of the Console Base (47) to prevent the Wire Harness from slipping. Then, cut off the ends of the plastic ties.

Route the Wire Harness (42) through the indicated open- ing in the Console Base (47). Attach the Wire Cover to the Console Base (47) with a 1/2” Silver Screw (48). Do not overtighten the Silver Screw.

Attach the Console Base (47) to the Crossbar (40) with two 3/4” Screws (2). Tighten the two Crossbar Screws (39) (only one Crossbar Screw is shown).

5
		Ground
			Wire
		75
		72
6	47
		42
	Ties
2	72	43
39		42
			5-pin	6-pin
7			47
Ties	42	Opening
			44
72
	40	48
	39		2

8