4
23. DANGER: Always unplug the power
cord immediately after use, before cleaning the
treadmill, and before performing the mainte-
nance and adjustment procedures described in
this manual. Never remove the motor hood un-
less instructed to do so by an authorized ser-
vice representative. Servicing other than the
procedures in this manual should be performed
by an authorized service representative only.
24.The treadmill is intended for in-home use
only. Do not use the treadmill in any
commercial, rental, or institutional setting.
25.If an outside antenna or cable system is con-
nected, be sure that the antenna or cable sys-
tem is grounded to provide some protection
against voltage surges and built-up static
charges. See Local Codes for information
with respect to proper grounding of the mast
and supporting structure, grounding of the
lead-in wire to an antenna discharge unit, size
of grounding conductors, location of antenna
discharge unit, connection to grounding elec-
trodes, and requirements for the grounding
electrode.
26.An outside antenna system should not be lo-
cated in the vicinity of overhead power lines
or other electric light or power circuits, or
where it can fall into such power lines or cir-
cuits. When installing an outside antenna sys-
tem, extreme care should be taken to keep
from touching such power lines or circuits, as
contact with them might be fatal.
27.To reduce the risk of electric shock, do not re-
move the cover or the back of the television.
There are no user serviceable parts inside.
Refer servicing to qualified service personnel.
28.Upon completion of any service or repairs to
the treadmill or the television, ask the service
technician to perform safety checks to con-
firm that the unit is in proper operating condi-
tion.
•Use No. 10 AWG (5.3mm2)copper, No. 8
AWG (8.4mm2)aluminum, No. 17 AWG
(1.0mm2)copper-clad steel or bronze wire,
or larger as a ground wire.
•Secure an antenna lead-in and ground wires
to the house with stand-off insulators
spaced from 4 to 6 feet (1.22 to 1.83m)
apart.
•Mount an antenna discharge unit as close
as possible to where the lead-in enters the
house.
•Use a jumper wire not smaller than No. 6
AWG (13.3mm2)copper, or the equivalent
when a separate antenna-grounding elec-
trode is used. See Local Codes.
Note to CATV system installer: See Local Codes
for grounding requirements.