5.The Console (5) requires four “D” batteries (not includ- ed); alkaline batteries are recommended. Press the tab on the battery cover, and lift off the battery cover.

Insert four batteries into the battery compartment.

Make sure that the batteries are oriented as shown by the diagram inside the battery compartment. Reattach the battery cover.

6.While another person holds the Console (5) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (86). Insert the excess wire harness into the Upright (2).

Attach the Console (5) to the Upright (2) with three M10 x 27mm Screws (71) and three M10 Split Washers (70). Be careful to avoid pinching the wire harnesses.

7.Apply a small amount of the included grease to the left and right axles on the Upright (2).

Identify the Left Handlebar (9) (refer to the drawing on page 4, if necessary). Carefully slide an Upright Spacer (26), a Handlebar Spacer (25), the Left Handlebar, and a Handlebar Cap (23) onto the left axle on the Upright (2) as shown. Slide an M10.3 Black Washer (53) onto an M8 x 19mm Button Screw (22), and tighten the Button Screw into the axle.

Attach the Right Handlebar (10) in the same way.

8.Hold the lower end of the Left Handlebar (9) inside of the Front Flex Bracket (17) on the left Flex Bar (14).

Apply grease to an M10 x 78mm Button Bolt (27). Attach the Left Handlebar (9) to the Front Flex Bracket

(17)with the Button Bolt, two M10 Zinc Washers (38), and an M10 Zinc Nylon Locknut (88). Do not over- tighten the Nylon Locknut; the Left Handlebar must be able to pivot freely.

Attach the Right Handlebar (10) to the right Front Flex Bracket (17) in the same way.

7

5

 

 

 

Tab

 

Battery

 

 

 

 

 

Cover

 

 

Batteries

 

 

 

 

 

 

 

5

6

 

 

 

 

 

 

5

 

 

 

Wire Harness

 

 

 

86

 

2

 

71

 

71

 

 

 

 

 

70

 

70

 

 

 

 

71

7

 

 

 

 

 

 

Grease

 

 

 

 

10

22

53

 

25

26

 

 

 

 

 

 

 

 

23

 

 

2

 

9

 

 

 

 

 

 

8

 

 

 

 

 

 

 

 

10

 

9

 

88

17

 

 

 

 

 

38

 

 

 

 

38

 

 

 

 

27

 

 

 

 

 

17

 

 

 

Grease

 

 

14

Page 7
Image 7
ProForm PFEL39011 user manual