ProForm PFEL54931 user manual Tighten both Shoulder Screws at the same time

9.Apply a small amount of the included Teflon® lubricant to a paper towel. Rub a thin film of the lubricant onto the Handlebar Legs (79). Next, identify the Left Handlebar (9) and the Right Handlebar (10), which are marked with stickers. Slide the Left Handlebar onto the left Handlebar Leg, and slide the Right Handlebar onto the right Handlebar Leg. Make sure that the

Handlebars are on the correct sides—the upper ends should bend in the direction shown.

Apply a generous amount of grease to the Pivot Axle

(88).Insert the Pivot Axle through the Right Handlebar (10), a Handlebar Spacer (25), and an Upright Spacer

(26)as shown. Next, insert the Pivot Axle into the Upright (2) until the left end of the Pivot Axle is flush with the left side of the Upright. Then, insert the Pivot Axle through the other Upright Spacer (26), the other Handlebar Spacer (25), and the Left Handlebar (9).

Slide an M10.3 Black Washer (53) onto an M8 x 19mm Shoulder Screw (22). Attach a Handlebar Cap

(23)to one end of the Pivot Axle (88) with the Shoulder Screw. Attach the other Handlebar Cap to the other end of the Pivot Axle in the same way.

Tighten both Shoulder Screws at the same time.

10.Attach the Water Bottle Holder (91) to the Upright

(2)with two M4 x 22mm Screws (93).

9
			10
			Grease
			53 22
			88
			23
9	26		25
			26
	25
	23		2
22		79
			Lubricant
	53		79
	Lubricant
10
			91
			93
			2

8