5.While another person holds the Upright (2) in the posi- tion shown, connect the Upper Wire Harness (86) to the Lower Wire Harness (87). Carefully pull the upper end of the Upper Wire Harness to remove any slack. While holding the Upper Wire Harness, insert the Upright into the Frame (1). Do not pinch the Wire Harnesses.
Slide an M10 Split Washer (70) and a Frame Spacer
(83)onto an M10 x 85mm Button Screw (63). Insert the Button Screw into the Frame (1) and the Upright
(2).Make sure that the concave end of the Frame Spacer is turned toward the Frame. Do not tighten the Button Screw yet.
6.While another person holds the Console (5) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (86). Insert the excess wire harness into the Upright (2).
Attach the Console (5) to the Upright (2) with four M4 x 16mm Screws (66). Be careful to avoid pinching the wire harnesses.
7.Identify the Left Pedal (13) and the Left Pedal Arm
(14).Attach the Left Pedal to the Left Pedal Arm with two M6 x 45mm Flat Screws (20).
Attach the Right Pedal (not shown) to the Right Pedal Arm (not shown) in the same way.
8.Apply a thin film of grease to the Left Crank Arm (36) in the indicated location.
Slide the Left Pedal Arm (14) onto the Left Crank Arm
(36).Attach the Left Pedal Arm with an M8 x 19mm Patch Screw (108) and an M8.5 Washer (53). Attach the Right Pedal Arm (not shown) to the right side of the elliptical crosstrainer in the same way.
7
5 | Make sure the | |||
| wire harnesses | |||
|
| do not get |
| |
|
| pinched and |
| |
2 | damaged during | |||
86 | this step. |
| ||
1 |
|
|
| |
87 | 70 |
|
| |
| 83 | 63 |
| |
|
|
|
| |
6 |
| Make sure the | ||
5 | wire harnesses | |||
| do not get |
| ||
86 |
| pinched and | ||
damaged during | ||||
| Console | this step. |
| |
|
|
|
| |
66 | Wire Harness |
|
| |
2 |
|
|
| |
7 | 20 |
|
|
|
|
|
|
| |
|
| 13 |
|
|
|
|
| 14 |
|
8 |
|
|
|
|
|
| Grease | 36 | |
|
| 14 |
|
|
| 108 53 |
|
| |
