ProForm PFEL54932 user manual Assembly

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver			, an adjustable
wrench	, and a rubber mallet	.

Refer to the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 22. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not found in the parts bag, check to see if it has been pre-assembled.

M6 Large	M8.5 Small	M8.5	M10 Split
Washer (94)–2	Washer (45)–2	Washer (53)–4	Washer (70)–1
Wave Washer	M10 Nylon	M4 x 16mm	M4 x 22mm
(116)–2	Locknut (106)–4	Screw (66)–4	Screw (93)–2
M6 x 16mm Button	M6 x 45mm Flat	M8 x 19mm Patch	M8 x 25mm Patch
Screw (109)–2	Screw (20)–4	Screw (108)–4	Screw (22)–2
	M10 x 112mm Carriage Bolt (34)–4
	M10 x 85mm Button Screw (63)–1

5