ProForm PFEL7806.1 user manual Wires 110, Ing the Controller Wires 95, 110 during this Step

8. Position an Inner Handlebar Cover (18) and an	8
Outer Handlebar Cover (19) around the Left
Handlebar (8) as shown. Then, pull the Left
Handlebar Wire (108) out of the Left Handlebar				79
and insert it through the Inner Handlebar Cover.				108
Attach the Inner and Outer Handlebar		8		79
Covers (18, 19) with three M4 x 16mm Self-tap-				18
ping Screws (79) and an M4 x 13mm Washer
(93). Start all three Self-tapping Screws	19		93	79
before tightening any of them. Avoid pinch-
ing the Left Handlebar Wire (108) during this				Avoid pinching
step.
				the Handlebar
Repeat this step for the Right Handlebar and				Wires (108, 109)
the Right Handlebar Wire (not shown).				during this step

9. Apply a generous amount of grease to the Pivot	9
Axle (65) and insert it into the Frame (2).
Pull the Left Controller Wire (110) through the left		Grease			95
Frame Cover (17), and then pull the Right			110		17
Controller Wire (95) through the right Frame
		65
Cover.	17				Avoid pinching
Attach each Frame Cover (17) to the Frame (2)				2	the Controller
	86				Wires (110, 95)
with two M4 x 16mm Screws (86). Avoid pinch-					during this step
ing the Controller Wires (95, 110) during this
step.

	86
10. Connect the Left Handlebar Wire (108) to the	10
Left Controller Wire (110). Insert the excess wire
into the Left Handlebar (8).	Avoid pinching
Apply a small amount of grease to both sides of	the wires during			9
	this step		110
a Wave Washer (98). Slide the Wave Washer
		108
onto the left side of the Pivot Axle (65). Next,
slide the Left Handlebar (8) onto the Pivot Axle	8
as shown. Attach the Left Handlebar with an
M10 x 23mm Shoulder Screw (80) and an	81			65
M10 x 20mm x 1mm Washer (81). Avoid pinch-		98
ing the wires during this step.	80
Repeat this step for the Right Handlebar (9).	Grease
	9