Connecting up02

10
En
2 Connect the AM and FM antennas.1
a. Pull off the protective shields of both AM
antenna wires. Connect one wire of the AM
loop antenna to each AM antenna
terminal.2
For each terminal, press down on the tab to
open; insert the wire, then release to
secure.
b. Push the FM antenna3 plug onto the center
pin of the FM antenna socket.
3-1 Connect each speaker.
• Connect the wires to the speaker.
• Twist and pull off the protective shields on
each wire.
• Match the color-coded wire with the color
indicator on the label, then insert the color-
coded wire into the red (+) side and the
other wire into the black (–) side.
HTZ180DVD only:
When you select the 3 spot speaker layout,
follow steps a through c below to set up the
speakers.
a. The base of each surround speaker fits
into the circular groove on the top of the
front speakers as shown.
Note
1 • Keep antenna cables away from the receiver and other cables.
• If reception with the supplied antenna is poor, see Improving poor FM reception on page 20 or Connecting external
antennas on page 42.
• Do not attach any antenna other than the provided loop antenna, or an external antenna as described on page 42.
2 • Don’t let it come into contact with metal objects and avoid placing near computers, television sets or other electrical
appliances.
• If radio reception is poor, you may be able improve it by re-inserting each antenna wire into the opposite terminal.
• For best reception, do not untwist the AM loop antenna wires or wrap them around the loop antenna.
3 To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of
the unit.
1
2
3
Color-coded wire
(Connect to speaker)
Color-coded connector
(Connect to rear panel)
Black (–) Color-coded wire
Red (+)
HTZ180_181_280_282DVD_En.book 10 ページ ２００９年３月１３日　金曜日　午後２時５０分