Pioneer S-DV280T manual Resetting the system, Using the language code list, Init OK is displayed

Additional information

Message	Description
STEREO	• STEREO appears when SURROUND or AUTO/STEREO is pressed in the TUNER,
	LINE or ADAPTER PORT input mode.
KEYLOCK	• The key lock is enabled. See Setting the Key Lock on page 52.
USB ERR	• See Important in Using the USB interface on page 31 for more on this.
HDMI ERR	• See HDMI connection above for troubleshooting tips. See also Resetting the HDMI
	connection on page 42 if the problem persists.
EEP ERR	• Contact your Pioneer authorized service center or your dealer for servicing.
EXIT	• Appears when any prohibited signal is input or the headphones are connected
	while the menu screen is displayed, and then the display returns to the normal
	display.
NO MIC	• Appears when you press SHIFT+KARAOKE, SHIFT+ECHO, SHIFT+, SHIFT+ or
	MIC VOL +/– when no mic is inserted.
OC ERR 1	• Check whether the speaker cables are short-circuited. If the error message
OC ERR 2	continues to be displayed, contact your Pioneer authorized service center or your
	dealer for servicing.
OVER TEMP	• Try lowering the volume. If this problem is not fixed by removing and inserting the
	power cable, this unit may be damaged. In such an event, please contact a Pioneer-
	authorized service center or your nearest dealer.
BT ERR	• Power consumption by Bluetooth ADAPTER is too high to supply the power.
	Reconnect the Bluetooth ADAPTER.
TV AUDIO	• Indicator is lit for two seconds if the listening mode is changed while HDMI audio
	mode is set for TV.
KARAOKE	• Appears when you press SURROUND, SOUND, AUTO/STEREO or MP3 EXP/
	V.ENH when a mic is inserted.
PHONESIN	• Appears when you press SURROUND, SOUND, AUTO/STEREO or MP3 EXP/
	V.ENH when a headphone is inserted.

13

English Deutsch Français Italiano Nederlands

Resetting the system

Use this procedure to reset all system settings to the factory default.

1With the system on, press SHIFT+SETUP.

2Use / to select INITIAL then press

ENTER.

3Use / to select ALL INIT then press

ENTER.

•INIT OK is displayed.

4Press ENTER while INIT OK is blinking.1

Using the language code list

Some of the language options (see Language settings on page 36) allow you to set your preferred language from any of the 136 languages in the Language code list below.

1Select ‘Other Language’.

2Use / to select either a code letter or a code number.

3Use / to select a code letter or a code number.

See the Language code list below for a complete list of languages and codes.

Español

Note

1 Do not operate the unit without reason or pull the power cord because the system’s power automatically turns on.

57

En