Manuals / ProForm / Lawn and Garden / Hot Tub

ProForm PFHS70071 Using the Restoration, Plugging in the Restoration, Starting the Restoration

Models: PFHS70071

1 20
Download 20 pages 33.5 Kb
Page 10
Image 10

USING THE RESTORATION 2.0

The RESTORATION 2.0 is designed to seat two adults. The six thera-jets can be regulated to provide a relaxing massage to sooth away stress, and the strength of the water massage can be adjusted by the air control. The RESTORATION 2.0 holds 120 gallons of water and offers an automatic, programmable heat- ing (70¡F to 104¡F) and filtration system.

The guidelines below explain how to properly use the RESTORATION 2.0. Follow these guidelines to main- tain the RESTORATION 2.0 for your long-term enjoy- ment.

PLUGGING IN THE RESTORATION 2.0

Once the RESTORATION 2.0 is filled with water and you have made sure that the cut-off valves to the pump are open, the power cord can be plugged in and the spa can be turned on. Note: The first time the power cord is plugged in, the spa will turn on auto- matically.

When connecting the power cord, plug the power cord directly into a grounded circuit capable of carrying 15 or more amps. No other appliance should be on the same circuit. Replace the power cord immediately if it becomes damaged.

Grounded circuit

capable of carrying

15 or more amps

GFCI

Test and Reset

Buttons

The power cord is equipped with a Ground Fault Circuit Interrupter (GFCI), located at the end of the power cord. You should always test the GFCI before using the RESTORATION 2.0.

First, turn on the RESTORATION 2.0 by pressing the power button on the console. Once the unit is run- ning, press the GFCI ÒtestÓ button. The RESTORA- TION 2.0 should shut off. Press the ÒresetÓ button. The RESTORATION 2.0 should resume normal oper- ation. If the RESTORATION 2.0 continues to run after the ÒtestÓ button is pressed, then the GFCI is dam- aged. Do not use the RESTORATION 2.0 until the GFCI has been repaired or replaced by a qualified electrician.

TESTING AND TREATING THE WATER

The RESTORATION 2.0 comes with a starter chemi- cal pack for maintaining the water in the spa. Disregard the directions on the individual packages of ÒQUICK pHix It DOWNÓ and ÒQUICK pHix It UP.Ó However, the directions on the bottle of ÒNon-chlorine ShoxÓ and ÒBromine BaseÓ are correct. Always keep the chemicals away from children and pets.

The first time you use the spa, you should test and treat the water. You must also treat the water each time you refill the spa. Once you have verified that the spa is functioning properly, and the water has cir- culated for a while, remove the spa cover and add 1/3 of the ÒBromine BaseÓ bottle, and 1/3 of the ÒNon- chlorine ShoxÓ bottle to the water. Allow the water to circulate for five minutes. You should now test the pH of the water. You will need a pH test kit (not included), which can be obtained at a pool and spa supply store. The pH reading should be between 7.2 and 7.8.

If the level is too low, add half of one of the ÒQUICK pHix It UPÓ packets to the water. Let the water circu- late through the spa for five minutes. Test the pH level again. Repeat until the pH level is correct.

If the level is too high, add half of one of the ÒQUICK pHix It DOWNÓ packets to the water. Let the water cir- culate through the spa for five minutes. Test the pH level again. Repeat until the pH level is correct.

See WATER CHEMISTRY on page 13 for information concerning proper water maintenance.

STARTING THE RESTORATION 2.0

Once you have tested the GFCI, you should verify the water flow from the pumping unit. Set the air control on the console to the lowest setting (see USING THE CONSOLE on the next page). The pumping unit will heat the water as it pumps. Cover the RESTORA- TION 2.0 with the spa cover. The spa cover must be tight and the insulation blanket in place. (See USING THE INSULATION BLANKET and SECURING THE SPA COVER on page 12.) The water will heat at about 2.0¡F an hour with the cover on. If you are using the spa indoors, and the room temperature is main- tained at 70¡F, it will take approximately 18 to 24 hours for the water to reach the set temperature.

The temperature and water flow can be set or changed by the controls on the console (see USING THE CONSOLE on the next page).

10

Page 9 Page 11
Page 10
Image 10
ProForm PFHS70071 manual Using the Restoration, Plugging in the Restoration, Testing and Treating the Water
Page 9 Page 11

PFHS70071 specifications

The ProForm PFHS70071 is a cutting-edge piece of fitness equipment designed for those who are serious about their workout routines. This treadmill incorporates advanced technology and a host of features aimed at enhancing user experience and overall effectiveness of workouts.

One of the standout features of the PFHS70071 is its powerful motor, capable of sustaining speeds of up to 12 miles per hour. This allows users to engage in intense running sessions or a gentle walk, making it suitable for all fitness levels. The running surface is spacious, offering ample room for comfortable strides at various speeds.

The treadmill also includes an impressive incline capability of up to 15%. This feature simulates uphill running, significantly increasing workout intensity and helping users build muscle while burning more calories. The digital LED display provides real-time data on important metrics, including distance traveled, speed, time, and calories burned, helping users monitor their progress effectively.

One of the key technologies incorporated in the PFHS70071 is the iFit compatibility. This allows users to access a wide variety of on-demand workouts led by professional trainers. Users can explore numerous routes and landscapes, thanks to the Google Maps integration, which adapts the incline of the treadmill to match the terrain of their selected route. This function keeps workouts fresh and engaging, offering almost limitless workout options.

The ProForm PFHS70071 is also designed with comfort in mind. The treadmill features ProShox cushioning technology, which reduces impact on joints and provides a more comfortable running experience. This is especially beneficial for those who may be prone to injuries or are recovering from them.

Safety is addressed through an emergency stop feature and a spacious safety zone, ensuring that users can exercise without worries. Additionally, the built-in Bluetooth speakers allow users to enjoy their favorite music or podcasts, making workouts more enjoyable.

In summary, the ProForm PFHS70071 treadmill combines power, technology, and user-friendly features to create a versatile fitness experience. It is designed to cater to various workout preferences, making it an ideal choice for both beginners and seasoned athletes looking to enhance their training routine. Whether you're running, walking, or utilizing the innovative iFit program, this treadmill offers a comprehensive solution to meet fitness goals and encourage a healthier lifestyle.