ASSEMBLY
Before you begin assembly, carefully read the following information and instructions:
¥Place all parts of the AIR WALKER in a cleared area and remove the packing materials.
IMPORTANT: DO NOT REMOVE THE RUBBER BANDS FROM THE HUB COVERS (see assembly step 5). Do not dispose of any packing materials until assembly is completed.
¥Use the drawings below to identify the small hardware used in assembly.
¥Read through each assembly step before you begin.
¥Make sure that all parts are oriented as shown in the drawings. Tighten all parts as you assemble them, unless instructed to do otherwise.
Assembly requires the following tools:
¥the included allen wrench
¥your own phillips screwdriver 
2 1/4" Lower Screw (26)Ð2
3/8" x 1" Screw (24)Ð8
2" Upper Screw (25)Ð2 | 3/8" Curved Washer (27)Ð4 | #8 x 1/2" Screw (31)Ð8 |
1.Before you begin, read the information at the top of this page.
See figure 1. Find the Left Upright (3). Note:
There is a ÒTOP LEFTÓ sticker on the upper end of the Left Upright.
See figure 1. Slide the Left Upright (3) onto the Base (1). Thread two 3/8Ó x 1Ó Screws (24) into the Left Upright. Do not tighten the Screws yet.
See figure 1. Attach the Right Upright (4) in the same manner.
2.See figure 2. Hold the Top Frame (2) level, and insert it into the Left and Right Uprights (3 and 4).
Note: It may be helpful to rock the Top Frame from side to side slightly as you insert it.
Make sure that the indicated rubber bands are not pinched between the Top Frame and the Uprights. Attach the Top Frame with four 3/8Ó x 1Ó Screws (24).
See figures 1 and 2. Tighten the eight 3/8Ó x 1Ó Screws (24).
Fig. 1
ÒTOP LEFTÓ | ÒTOP RIGHTÓ | |
Sticker | ||
Sticker | ||
| ||
3 | 4 | |
| ||
24 |
|
1
Fig. 2 | 2 | Rubber |
| ||
| Rubber | Band |
| Band |
|
24
24 4
24
3
4
