5. See figure 5a. Before you begin this step, | Fig. 5a |
|
|
make sure that the Right Hub Cover (19) is |
|
| |
|
|
| |
attached to the Top Frame (2) with a rubber |
|
|
|
band as shown. If the Right Hub Cover has |
|
|
|
come off during shipping, see figure 5b. |
| 2 |
|
Slide the Right Hub Cover onto the Right |
|
| |
|
|
| |
Pivot Bracket (20). |
| Rubber Band | |
|
| ||
See figure 5a. Find the two holes inside the slot | Note: Tighten the | Hole |
|
of the Right Hub Cover (19). Make sure that the |
| ||
rubber band is not covering the holes, and that | 2Ó Upper Screw |
| 19 |
(25) first. |
| ||
the holes are aligned. |
|
| |
|
|
| |
See figure 5a. Hold the Right Leg (7) against | 25 |
|
|
| Hole |
| |
the Right Hub Cover (19). Thread the 2Ó Upper | 26 |
| |
|
| ||
Screw (25) two complete turns into the upper |
|
|
|
hole inside the Right Hub Cover. Thread the |
|
|
|
2 1/4Ó Lower Screw (26) two complete turns |
|
| 7 |
into the lower hole. Break and remove the rub- |
|
| |
|
|
| |
ber band. |
|
|
|
See figure 5a. Fully tighten the 2Ó Upper Screw | Fig. 5b |
|
|
|
|
| |
(25). After the 2Ó Upper Screw is tightened, fully |
|
|
|
tighten the 2 1/4Ó Lower Screw (26). |
|
|
|
Repeat assembly steps 3, 4, and 5 to attach | ÒRIGHTÓ |
|
|
Sticker |
|
| |
the Left Leg and the Left Handle (not shown) to | 20 |
| |
|
| ||
the left side of the AIR WALKER. |
|
|
|
| 19 |
|
|
6. See figure 6a. Insert two ÒAAÓ batteries (not includ- | Fig. 6a |
|
|
ed) into the Monitor (39). Alkaline batteries are |
|
| |
Batteries | 39 |
| |
recommended. Make sure that the negative (Ð) |
| ||
|
| ||
ends of the batteries are touching the springs, | 40 |
|
|
and that the positive (+) ends of the batteries |
|
|
|
are pushed against the metal contacts. |
|
|
|
See figure 6a. Plug the Reed Switch Wire (44) |
| Fig. 6b | 40 |
|
|
| |
into the Monitor (39). Insert any excess wire into |
|
| 39 |
the Console (40). |
|
| |
44 |
|
| |
|
|
| |
See figure 6b. Snap the Monitor (39) into the |
|
|
|
Console (40). Be careful not to pinch the wire |
|
|
|
between the Monitor and the Console. |
|
|
|
Before you use the AIR WALKER, use the included allen wrench to firmly
6
