7
4. See the inset drawing. Remove the rubber bands
from the screws. Be sure that the Arm Brackets (31)
inside the tubes on the left side of the Base (1) are
pressed against the indicated sides of the tubes.
Align the posts on the Left Armrest (6) with the tubes
on the Base (1). Slide the Left Armrest onto the
Base. You may need to flex the posts away from the
Left Side Shield (8) to assemble it past the Bracket
Screws (32) in the Base.
Attach the Pillow (13) to the fastener strip.
5. Raise the footrest by pulling on the Footrest Control
Arm (23, not shown). Attach the lower end of the
Right Side Shield (7) to the right side of the Base (1)
with two Arm Cover Screws (35) and two M6
Washers (95).
Attach the lower end of the Left Side Shield (not
shown) in the same manner.
Using the included allen wrench, tighten the four
Bracket Screws (32) in the right side of the Base (1).
Tighten the four Bracket Screws (not shown) in the
left side of the Base in the same manner.
6. Plug the cord from the Hand Control (22) into the
socket on the back of the massage chair. Be sure to
align the indicated tabs.
5
131 31
1
8
6
32
13
32
32
35
95
35
95
7
1
22
Socket
Tabs
6
Note: Parts of the chair are cut away for clarity
4