To drain the hydrotherapy spa, follow the steps below: WINTER USE AND CARE
1.Using the console, adjust the temperature to the lowest setting.
2.Shut off the power to the spa, at the circuit breaker or GFCI.
3.Remove the access panel from the spa (see
ATTACHING AND REMOVING THE ACCESS PANEL on page 14).
4.Pull the hose out and hold it above the waterline. Remove the cap, open the valve knob, and attach a garden hose to the drain hose. Lower the hose and drain the spa.
Cap | Valve | Drain |
| Hose | |
| Knob | |
|
|
5.When the spa is empty, remove the garden hose, close the valve knob,
6.
7.Refill the spa and treat the water with chemicals (see pages 10 and 13).
DRAINING THE PUMP
After the hydrotherapy spa is drained, the jet pump should also be drained if the spa will be stored for more than thirty days or if it may be exposed to freez- ing temperatures.
The hydrotherapy spa is designed for
1.Make sure the power to the spa is turned off.
2.Drain the spa (see DRAINING THE HYDROTHER- APY SPA on the previous page and this page).
3.Remove all remaining water from the spa shell. Dry the spa shell with towels.
4.Set the air controls to the lowest setting. Use a wet/dry vacuum to pull any remaining water from the system. To do this, place the vacuum nozzle over each jet, starting with the highest jet and fin- ishing with the lowest jet.
5.Set the air controls to the highest setting and repeat step 3.
6.Drain the pump (see DRAINING THE PUMP on this page). Once the water is drained from the pump, place the vacuum nozzle over the drainage hole in the pump and vacuum any additional water from the pump. Note: For additional protection, remove the pump from the spa and store it in a
7.Clean the spa shell (see page 13).
8.Clean the filter (see page 13).
9.Shut the power off at the breaker. Label the breaker in such a way that the breaker will not be turned on accidentally.
10.
REPLACING THE LIGHT BULB
If the underwater light burns out, you will need to remove the access panel to replace it (see ATTACHING AND REMOVING THE ACCESS PANEL on page 14). Make sure the spa power is turned off. Next, locate the light housing. Turn the light housing counterclockwise and remove it from the spa shell.
Light Housing | Light |
| Bulb |
Turn off the power to the spa. To drain the jet pump, remove the access panel from the spa unit (see ATTACH-
ING AND REMOVING THE ACCESS PANEL on page 14). Locate the jet pump inside the spa. Loosen the indi- cated collar on the pump.
Collar |
Light
Housing
To replace the light bulb, pull the old light bulb out of the housing and insert a new light bulb.
15