Using the Controls
Waterfall knob | Console |
| |
Air Control M | Display |
| |
|
|
| |
Air Control L |
|
|
|
Diverter Knob |
|
|
|
Temperature | Jet | Light | Temperature |
Up Button | Button | Button | Down Button |
Refer to the diagram above. The function of each control is explained below:
Jet Button: Turns the spa jets on and off. If the but- ton is pressed once, the spa jets will run at low speed, providing gentle hydrotherapy. If the button is pressed again, the jets will run at high speed, providing more intense hydrotherapy. If the button is pressed a third time, the jets will shut off.
The spa also features an automatic mode that heats and filters the water when the spa is left unattended. When the power to the spa is first turned on, or if the water temperature is below the set temperature, the water will be heated as required to maintain the set temperature. Note: To keep the filter and heat cycles from running, the power to the spa must be turned off.
Light Button: Turns the underwater light on and off.
Temperature Buttons: Control the temperature setting of the water. The temperature can be set between 80°F and 104°F. The water heats at about 6°F per hour with the cover on. Use a medical or other accu- rate thermometer to check the temperature of the water. Note: The word “COOL” will appear in the con- sole display if the temperature of the water is more than 20°F cooler than the set temperature. When this happens, the heater will automatically activate to warm the water. The word “ICE” will appear in the display if the temperature drops below 40°F. If this happens, the pump will automatically circulate the water and warm the plumbing to keep the water from freezing.
Air Controls: Determine the amount of air flowing through the spa jets during operation. Refer to the diagram at the right. Air control M controls air flow to
the jets labeled M. Air control L controls air flow to the jets labeled L. If a control is turned counterclockwise, the amount of air flowing through the jets will increase. If the control is turned clockwise, the amount of air will decrease.
Waterfall Knob: Controls the flow of water through the waterfall.
Diverter Knob: Diverts the water flow two ways. If the knob is turned clockwise, water is diverted to the seats labeled 1, 2, and 4 below. If the knob is turned counterclockwise, water is diverted to the seats labeled 3 and 5 below and the volcano jet (see F on the SPA SHELL DIAGRAM on page 11). Note: The diverter knob may be difficult to turn while the pump is running at high speed.
| 2 |
L | 3 |
1 | M |
| 4 |
| L |
| M |
L | 5 |
|
12
