ProForm PFTL312040 Inserted PROPERLY, the Console MAY be, Damaged When the Power is Turned on

5. Place the Console Base (46) on the Right Handrail (47)

and the Left Handrail (not shown). Attach the Console

Base with four 3/4” Screws (13) (only two Screws are

shown). Do not tighten the Screws yet.

Insert the Wire Harness (21) through the two indicated

plastic ties on the Console Base (46). Next, insert the

Wire Harness up through the opening beside the Console

Cover (96). Make sure that the Console Cover is securely

attached to the Console Base.

See the inset drawing. Look at the top of the Console

Base (46). Insert the Wire Harness (21) through the plas-

tic tie on top of the Console Base.

6. Hold the Console (10) near the Console Base (46).

Touch the Right Handrail (47) to discharge any static.

See the inset drawing. Find the 3-wire connector on the

end of the Wire Harness (21). Insert the connector into

the red socket beneath the console. The connector

should slide easily into the socket and snap into

place. If the connector does not slide easily and snap

into place, turn the connector and then insert it. Insert the

5-wire connector into the black socket beneath the con-

sole in the same way.

Insert the excess Wire Harness (21) down through the

opening in the Console Base (46 [see the inset drawing

in step 5]). Securely tighten the plastic tie on top of

the Console Base to prevent the Wire Harness from

slipping. Then, cut off the end of the plastic tie.

Make sure that the connectors and wires appear as

shown at the right. IF THE CONNECTORS ARE NOT

INSERTED PROPERLY, THE CONSOLE MAY BE

DAMAGED WHEN THE POWER IS TURNED ON.

5	46
		21
		96
	Ties
13	47
		21
		Tie
		46
6
	21	10
Ties		46

	13		13
		97
47

See drawing 6a. Press the Bookrack (90) onto the Console

Base (46) in the location shown.

Set the Console (10) on the Console Base (46). Insert

the excess Wire Harness (21) into the large hole in the

side of the Right Handrail (47). Securely tighten the

plastic ties on the bottom of the Console Base to

prevent the Wire Harness from slipping. Then, cut off

the ends of the plastic ties.

21

6a

3-wire 5-wire

Attach the Console (10) to the Console Base (46) with four

3/4” Screws (13) and two 1/2” Silver Screws (97). Start all

six Screws before tightening them; do not over-

tighten the Screws.

90

46

8