5. Loosen the two Crossbar Screws (98) (only one is shown) |
several turns. Place the Console Base (87) on the Right |
Handrail (16) and the Left Handrail (not shown). Make |
sure that the Wire Harness (53) is not pinched by the |
Right Handrail. Attach the Console Base with four 3/4” |
Screws (5) (only two Screws are shown). Start all four |
Screws before tightening any of them. |
Insert the Wire Harness (53) through the two indicated |
plastic ties on the Console Base (87). Next, insert the |
Wire Harness up through the opening beside the Wire |
Cover (10). Make sure that the Wire Cover is securely at- |
tached to the Console Base. |
See the inset drawing. Look at the top of the Console |
Base (87). Insert the Wire Harness (53) through the plas- |
tic tie on top of the Console Base. |
6. Hold the Console (10) near the Console Base (87). |
Touch the Right Handrail (16) to discharge any static. |
See the inset drawing. Find the |
end of the Wire Harness (53). Insert the connector into |
the red socket beneath the Console. The connector |
should slide in easily and snap into place. If it does |
not, turn the connector and then insert it. Insert the 6- |
wire connector into the other socket beneath the Console |
the same way. |
Insert the excess Wire Harness (53) down through the |
opening in the Console Base (87) (see the inset drawing |
in step 5). Securely tighten the plastic tie on top of |
the Console Base to prevent the Wire Harness from |
slipping. Then, cut off the end of the plastic tie. |
5 |
| 87 |
|
|
|
| |
|
|
| 53 |
|
|
| 10 |
|
| Ties |
|
5 | 98 | 16 |
|
|
|
| 53 |
|
|
| Tie |
|
|
| 87 |
6 |
|
|
|
|
| 53 | 10 |
| Ties |
| 87 |
97
98 | 5 | 5 | 97 |
|
|
|
16
97
Make sure that the connectors and wires appear as |
shown at the right. IF THE CONNECTORS ARE NOT |
INSERTED PROPERLY, THE CONSOLE MAY BE |
DAMAGED WHEN THE POWER IS TURNED ON. |
See drawing 6a. Press the Bookrack (85) onto the Console |
Base (87) in the location shown. |
Set the Console (10) on the Console Base (87). Insert |
the excess Wire Harness (53) into the large hole in the |
side of the Right Handrail (16). Securely tighten the |
plastic ties on the bottom of the Console Base to |
prevent the Wire Harness from slipping. Then, cut off |
the ends of the plastic ties. |
Attach the Console (10) to the Console Base (87) with two |
3/4” Screws (5) and four 1/2” Screws (97). Start all six |
Screws before tightening any of them; do not over- |
tighten the Screws. Tighten the two Crossbar Screws |
(98) (only one is shown). |
536-wire
6a
85 
87
8
