3.Insert a Plastic Shim (104) into each side of the post on the right side of the Base (11). Next, orient the Right Handrail (103) as shown, and insert it into the Base. Be careful to avoid pinching the Handrail Wire Harness (21). Note: If necessary, tap the Right Handrail with a rubber mallet until it is fully seated in the Base. If the Right Handrail cannot be fully seated, remove the outer Plastic Shim and then insert the Right Handrail.
Attach the Right Handrail (103) to the Base (11) with three 1” Bolts (8) and three 1/4” Star Washers (9). Do not tighten the Bolts yet.
Assemble the Left Handrail (not shown) in the same way. Note: There is not a wire in the Left Handrail.
4.Hold the Crossbar (1) between the Handrails (102, 103). Attach the Crossbar with two Crossbar Screws (53). Do not tighten the Crossbar Screws yet.
Attach the ring on the end of the ground wire to the small hole in the side of the Right Handrail (103) with a Silver Ground Screw (109).
5.Hold the Left Upper Body Arm (89) near the Left Handrail
(102)as shown. Make sure that the Resistance Knob
(98)is on the indicated side. Attach the Left Upper Body Arm to the Left Handrail with two 3” Bolts (78), two Washers (39), and two 3/8” Star Washers (29) as shown.
Attach the Right Upper Body Arm (94) to the Right Handrail (103) as described above. Be careful not to pinch the wires in the Right Handrail.
3 |
|
|
| 103 |
|
|
| 21 |
| 104 | 9 |
| 8 | |
|
| |
| 9 |
|
| 8 | 11 |
4 |
|
|
| 1 |
|
| 109 |
|
| 53 |
|
102 | Ground |
|
| Wire |
|
| 103 |
|
|
| 53 |
5 |
|
|
102 | 89 | 94 |
|
| |
29 |
|
|
39 |
|
|
78 | 98 |
|
| 103 |
|
| 39 |
|
| 78 | 29 |
|
|
6
