ProForm PFTL49101 user manual Console Base 46. Important Make sure that the, Screws

3. Attach the Weight Rack (90) to the Uprights (11) with the	3
two Rack Washers (41) and Rack Bolts (89). Note: If nec-
		41	89
essary, spread the Uprights apart to align the holes in the				90
					41
Weight Rack with the holes in the Upright.
					89
Insert the Right Handrail (88) into the upper end of the		11
right Upright (11), with the lower end of the Handrail on					11
the side of the Extension Leg (34) as shown. Have a sec-				88
ond person hold the Right Handrail until step 4 is com-
pleted.
4. With the help of a second person, lower the Uprights (11)					34
until the Left and Right Handrails (1, 88) are resting on
the floor. Attach the lower end of the Right Handrail (88)	4
to the Extension Leg (34) with a Handrail Bolt (91), a
Handrail Washer (92), and a Handrail Nut (47) as shown.
Note: It may be necessary to push on the lower end of
the Handrail to align the hole in the Handrail with the hole					34
in the Extension Leg.		11
					47
Attach the Left Handrail to the left Extension Leg (not
shown) as described above.		88			92
Raise the Uprights (11) to the position shown in step 3.					91
5. Cut and remove the plastic tie on the right Upright (11).	5	11
Place the Console Base (46) on the Uprights (11) (only	Cable
the right Upright is shown). Wrap the cable tie around the	Tie
Wires (21) or pull the Wires through the cable tie loop.
Pull the cable tie tight and cut off the end of the cable tie.
Connect the two Wires (21) to the two connectors in the			21
Console Base (46). Important: Make sure that the
	Plastic Tie				Connectors
Wires are fully inserted. WARNING: Do not discon-
					46
nect or connect the Wires while the treadmill power					33
cord is plugged in. Loosely thread four Screws (33) into
the Uprights and the Console Base. After all four Screws
have been started, tighten the Screws until they are			90
snug; do not overtighten the Screws.	6
6. Attach the Storage Latch (14) to the left Upright (11) with
two Screws (33). Be careful not to overtighten the
Screws.		11
Place the 3-lb. Weights (79) in the center slots of the			14	33	79
Weight Rack (90), the 2-lb. Weights (not shown) next,
and the 1-lb. Weights (not shown) in the outer slots.

7.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.

6