ProForm PFTL49210 user manual Assembly, Phillips screwdriver Mallet Wire cutters, Pliers

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the parts used in assembly. Assembly requires the following tools: The included allen wrench and your own

phillips screwdriver		, mallet	wire cutters	and needle-nose
pliers	.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Handrail Bolt (78)–2

Screw (101)–4

Long Screw (79)–4	Short Handrail Bolt (89)–2	Small Handrail
	Washer (36)–2	Washer (29)–2

1. With the help of a second person, carefully raise the	1
Uprights (82) until the treadmill is in the position shown.
Insert one of the Extension Legs (103) into the treadmill			82
as shown. Make sure that the Thick Base Pad (97) is on
the indicated side. Note: It may be helpful to tip the
Uprights (82) in the direction shown by the arrow as you
insert the Extension Leg. To fully insert the Extension
Leg, it may be necessary to tap it with a mallet.
Insert the other Extension Leg (103) in the same way.					82
2. Refer to drawing 2a. If there is a plastic tie in the Cage
Nut (109) in the Right Handrail (85), remove the plastic
tie. Pull 5 to 6” of the Wire Harness (26) out of the Right				97	103
Upright (82). Route the Wire Harness through the bracket
on the Right Handrail and out of the indicated hole. If nec-
essary, use needle-nose pliers to grip the connectors on	2a		2c
the Wire Harness. Thread the included wire tie through				26
the indicated hole in the Right Handrail (85).	85		23
Refer to drawing 2b. Look into the Right Handrail (85)		26			89
		Tie			29
and make sure that the Wire Harness (26) has been se-
	109
cured to the side shown. Tighten the wire tie and cut off			85
the excess from the end.
	82
			82
Refer to drawing 2c. Insert the bracket on the Right
	2b	Tie
Handrail (85) into the upper end of the right Upright (82),
with the lower end of the Right Handrail on the Extension	85
Leg (103). Tighten a Short Handrail Bolt (89) with a Small		26
Handrail Washer (29) into the upper end of the Upright.
Attach the Left Handrail (23) as described above. Note:					103
There is not a wire in the left Upright (82).

5