3.With the help of a second person, carefully tip the Uprights (82) down as shown.
Align the lower ends of the Handrails (23, 85) with the holes in the Extension Legs (103). Tighten a Handrail Bolt (78) with a Washer (36) through each Extension Leg into each Handrail. Attach each Extension Leg with two Screws (101) and a Base Pad (52) as shown. Make sure that the Extension Legs are fully inserted into the Uprights (82), and push down on the Uprights as you tighten the Screws. Tighten the Handrail Bolts (78).
Note: One replacement Base Pad (52) and Spacer (not shown) may be included. If a Base Pad becomes worn and needs to be replaced, use the replacement Base Pad. If a Thick Base Pad (97) needs to be replaced, use the replacement Base Pad with the Spacer.
With the help of a second person, carefully tip the Uprights (82) back to the upright position.
4.Place the Console Base (87) on the Handrails (85, 23). Make a loop with the indicated plastic tie and insert the two Wires (26) through the loop. Pull out only enough of the two Wires to connect them to the connectors in the Console Base. Important: Make sure that the Wires are fully inserted. Tighten the loop and cut off the excess tie.
WARNING: Do not disconnect or connect the Wires while the treadmill power cord is plugged in.
Refer to drawing 4b. Thread four Long Screws (79) into the Handrails (85, 23) and the Console Base (6). After all four Long Screws have been started, tighten the Screws until they are snug; do not overtighten the Screws.
5.Remove the Lock Knob (105) from the Lock Pin (11).
Make sure that the Lock Pin Collar (14) and the Spring
(56)are on the Lock Pin as shown. Insert the Lock Pin into the Latch Bracket (77).
Tighten the Lock Knob (105) onto the Lock Pin (11).
3 |
| 97 |
|
|
|
|
|
|
|
| |
|
|
|
|
| 82 |
|
|
|
|
| 52 |
|
|
|
|
| 101 |
|
|
| 23 |
| 78 |
| 82 | 52 | 103 | 36 | |
|
| ||||
|
|
|
| ||
85 |
| 101 |
| 97 |
|
|
|
|
|
| |
103 |
| 78 |
|
|
|
| 36 |
|
|
| |
| 97 |
|
|
| |
|
|
|
|
| |
4a |
|
|
|
|
|
85 |
|
|
|
| 87 |
|
|
|
| 26 |
|
|
| Tie |
|
|
|
4b |
|
|
|
| 87 |
|
|
|
|
| |
85 |
|
|
|
|
|
|
|
|
|
| 23 |
|
| 79 |
|
| 79 |
|
|
|
|
| |
5 |
|
|
|
|
|
|
| 105 |
|
|
|
|
| 77 | 56 | 14 | 11 |
|
|
| |||
6.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor, place a mat under the treadmill.
6
