18
5. Follow your progress with the displays.
When the
manual
mode is
selected, the
upper half of
the display
will show a
track that represents 1/4 mile (400 m). As you walk
or run, indicators will appear in succession around
the track until the entire track appears. The track
will then disappear and the indicators will again
begin to appear in succession.
The upper half of the display can also show the
elapsed time, the distance you have walked or
run, the speed of the walking belt, the approximate
number of calories you have burned, your pace in
minutes per mile, and the incline of the treadmill.
Press the Priority Display button repeatedly until
the desired workout information appears.
The lower left corner
of the display will show
the elapsed time, the
distance that you have
walked or run, and
the incline level of
the treadmill. Note: When an onboard workout is
selected, the display will show the time remaining
in the workout instead of the elapsed time.
The lower right corner
of the display will show
the approximate number
of calories you have
burned, the speed of
the walking belt, and
your pace in minutes per mile. The right side of the
display will also show your heart rate when you use
the handgrip heart rate monitor.
To reset the display, press the Stop button, remove
the key, and then reinsert the key.
6. Measure your heart rate if desired.
Before using the handgrip heart rate monitor, re-
move the sheets of plastic from the metal contacts
on the pulse bar. In addition, make sure that your
hands are clean.
To measure your heart rate, stand on the foot
rails and hold the pulse bar with your palms on
the metal contacts for approximately ten seconds;
avoid moving your hands. When your pulse is
detected, a heart symbol in the calorie display
will ash each time your heart beats, one or two
dashes will appear, and then your heart rate will be
shown. For the most accurate heart rate read-
ing, continue to hold the contacts for about 15
seconds.
7. Turn on the fan if desired.
The fan features multiple
speed settings. Press
the fan increase or de-
crease button to select a
fan speed or to turn off
the fan. Note: If the fan
is on when the walking
belt is stopped, the fan
will turn off automatically
after a few
minutes.
8. When you are nished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest set-
ting or you may damage the treadmill when you
fold it to the storage position. Next, remove the
key from the console and put it in a secure place.
When you are nished using the treadmill, press
the power switch into the off position and unplug
the power cord. IMPORTANT: If you do not do
this, the treadmill’s electrical components may
wear prematurely.
Contacts
Decrease
Increase
Track