ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench | and your own phillips screwdriver | (with |
a shaft at least 6” long) and wire cutters | . |
|
Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled.
Extension Leg Nut | Star Washer | 1” Tek Screw | Latch Screw |
Console Bolt | Extension Leg Bolt |
1. Make sure that the power cord is unplugged. | 1 |
|
| |
|
|
| ||
With the help of a second person, carefully tip the |
|
| 84 | |
|
|
| ||
treadmill onto its left side as shown. Partially fold the |
|
|
| |
Frame (58) so the treadmill is more stable. Do not fully | 65 |
|
| |
fold the treadmill until it is completely assembled. |
|
| ||
8 | 82 | 82 | ||
| ||||
|
|
| ||
Insert an Extension Leg (89) into the base of the Uprights |
|
|
| |
(84) as shown. Next, insert two Extension Leg Nuts (67) |
|
|
| |
into the bottom of the Extension Leg. Hold the Extension |
|
| 83 | |
Leg Nuts in place and insert two Extension Leg Bolts (65) |
|
| ||
|
|
| ||
with Star Washers (8) into the top of the Extension Leg. |
|
| 67 | |
Firmly tighten the Extension Leg Bolts into the Extension |
| 89 | ||
Leg Nuts. Attach the other Extension Leg in the same |
|
| ||
|
|
| ||
way. With the help of a second person, carefully tip the | 58 |
|
| |
treadmill onto the other side and attach the other |
|
| ||
Extension Leg. |
|
|
| |
Attach four Base Pads (82) to the base of the Uprights |
|
|
| |
(84) with four 1” Tek Screws (83) (only two are shown). |
|
|
|
6
