ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrenches | and your own Phillips screwdriver | , | |
wire cutters | , and rubber mallet | . |
|
For help identifying the assembly hardware, see the drawings below. Note: The assembly hardware and other small parts are packaged in separate part bags. If a part is not found in the part bags, check to see if the part has been preassembled.
3/4” Screw | 1” Tek Screw |
| 1” Screw (117) |
|
|
|
|
|
|
|
|
|
|
|
|
1” Bolt
Internal Star
Washer
1.With the help of a second person, carefully raise the treadmill to the upright position as shown.
Insert one of the Extension Legs (106) into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (100) is on the bottom. If necessary, tip the Uprights (82) forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same way.
Note: To prevent damage to the Upper Body Arms (35) if they are moved too far sideways, the lower end of each Upper Body Arm features a breakaway connector. If one of the Upper Body Arms breaks away, simply press the lower end back onto the Ball Joint (7 [not shown]).
1 |
82 |
35 |
35 |
106 |
100 |
6
