4.Hold the Console Base (47) near the Left Handrail (71). Attach the ends of the ground wires on the Console Base to the indicated small hole in the Left Handrail with the Silver Ground Screw (75).
5.Touch the Right Handrail (72) to discharge any static. Slide the sleeve off the connector as shown in the inset drawing. Press the end of the Upright Wire (42) into the socket in the bottom of the Console Base (47). The con- nector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connector and then insert it. Slide the sleeve back over the connector.
6.Set the Console Base (47) on the Right Handrail (72) and the Left Handrail (71). Attach the Console Base with four 1/2” Screws (48). Start all four Screws before tighten- ing them; do not overtighten the Screws.
4 |
|
|
| Ground | |
| Wires |
|
| 47 |
|
| Small |
|
| Hole |
|
| 71 | 75 |
|
| |
5 |
|
|
| 72 |
|
|
| 47 |
|
| 42 |
| Sleeve | Connector |
| 42 |
|
6 | 47 |
|
|
| |
72 |
| 71 |
| 48 |
|
|
| 48 |
8
