8.Set the console assembly face down on a soft surface to avoid scratching the console. Identify the Right Handrail (79). Hold the Right Handrail near the console assembly. Route the console wire through the large holes in the top and bottom of the Right Handrail.
Set the Right Handrail (79) on the Console Frame (81). Start a 1/4" x 1/2" Screw (8) with a 1/4" Star Washer (12) into the Right Handrail. Then, start two 5/16" x 1 1/2" Bolts (4) with two 5/16" Star Washers (9) into the Right Handrail.
Make sure that the console wire is not pinched. Start the Screw and both Bolts, and then tighten them.
Attach the Left Handrail (not shown) as de- scribed above. Note: There is not a wire on the left side.
9.With the help of a second person, hold the con- sole assembly near the Right Upright (83) and the Left Upright (not shown).
Connect the Upright Wire (85) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Remove the wire tie from the Upright Wire.
8 |
| 8 | Console |
| |
79 | 12 | 4 | |||
| Wire | ||||
|
|
|
| 9 | |
Console |
|
|
|
| |
Assembly |
|
|
| 81 | |
|
|
|
|
9 | Console |
|
|
| Assembly |
|
|
| Console |
|
|
| Wire | 85 |
|
| Wire |
| |
|
| Console | |
| Tie | 83 | |
|
| Wire | |
|
|
| 85 |
11
