ProScan 37LC30S57 user manual ImPortant safety instructions, Tc% EOR, $2898A

ImPortant safety instructions

15.POWER SOURCE: This TV should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. For TVs intended to operate from battery power, or other sources, refer to the operating instructions.

16.POWER CORD PROTECTION: Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

17.OUTDOOR ANTENNA GROUNDING : If an outside antenna or cable system is connected to the TV, be sure

the antenna or cable system is grounded to provide

some

protection

against

voltage

surges

and

built-up

FIGURE A

.-_:---.

static

charges.

Section

810

of the

National

Electrical

EXAMPLE OF ANTENNA GROU NDING AS PER

_

ANTENNALEAD

NAT,ONALELECTR,CALOODE

Code,

ANSI/NFPA

NO.70,provides

information

with

,_ _NW_RE

structure,respect

to

groundingproper groundingof the

leadof the-in

mastwire toand ansupportingantenna

_

GROUNDCLAMP__I_-

'

_

discharge

unit

,

size

of

grounding

conductors,

location

_

_,_

,",Tc% EOR,

-,

of antenna

discharge

unit,

connection

to

grounding

i_,_-.........'

electrodes,

and

requirements

for

the grounding

ELECTRIC

electrode.

(Fig.A)

SERVICE

<s:_

/

/

j_

_

_

J-_

GROUNDING WIRES

118. LIGI-ITNTNG:

For added

protection

for

this

TV receiver

o

P

during

a lightning

storm,

or when

it is left

unattended

$2898A

o SE,oGROURO.N_

ELECTRODE SYSTEM

and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the TV due to lightning and power line surges.

119.POWER LlrNES: An outside antenna system should not be located in the vicinity of overhead power lines, or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as

contact with them might be fatal.

20, OVERLOADING: Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

211.OB3ECT AND LIQUID ENTRY: Never push objects of any kind into this TV through openings as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill liquid of any kind into the TV.

22. SERVICING: Do not attempt to service this TV yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel

23.REPLACEMENT PARTS: When replacement parts are required, be sure that the service technician uses

replacement parts with the same characteristics as the original parts specified by the manufacturer.

Unauthorized substitutions may result in fire, electric shock, injury to persons or other hazards.

24.SAFETY CHECK: Upon completion of any service or repairs to this TV, ask the service technician to perform routine safety checks to determine that the TV is in proper operating condition.

25.The apparatus should not be exposed to any dripping or splashing, and no objects filled with liquids (such as a vase) should be placed on the apparatus.

26.WARNING= Plug the power cord into a power outlet where access to a power cord connector is readily accessible, in case if the power needs to be immediately disconnected.

27. ATTENTION:

This

device

complies

with

Part

15 of the

FCC Rules. Operation

is subject

to the

following two

conditions:

(1) this

device

may

not

cause

harmful

interference,

and (2)

this

device must

accept

any

interference

received, including

interference

that

may

cause

undesired

operation.

28.CAUTION: To reduce the risk of electric shock, the grounding of the center pin of this plug must be maintained.

4