Back Panel: Power
The C250 is equipped with the standard, internationally accepted 15 amp IEC. This device is labeled, “AC input.” With the supplied power cord, or with another high- end after market cable like the PS Audio Lab Cable II, connect the C250 to a power source.
The C250 is internally equipped with a PS Audio Power Plant. This circuit was spe- cifically tailored for the C250 input stage.
The primary function of this power plant is to regulate and optimize the power line signal for the input stage, however you may still choose to plug the C250 into a PS Audio P1200 Power Plant to obtain additional levels of enhancement. Other- wise, simply connect the C250 directly into your wall receptacle.
The C250 is equipped with a 3 amp fast blow fuse to provide protection for the regenerator (power plant) board. This fuse can be located where it says, “Regenera- tor Fuse.” There is another fuse to provide protection for the main amplifier circuitry, which has a 15 amp slow blow rating. This fuse can be located where it says, “Main Fuse.”
You will find two spare fuses along with this user’s guide should you need them. To obtain specific information on how to replace a fuse, or more importantly to de- termine if the fuse needs replacing, refer to the service section at the end of this manual.
The C250 is capable of handling either
Specifications
Stereo 8 ohm power |
| 250 watts RMS | |
Stereo 4 ohm power |
| 500 watts RMS | |
Mono power | 1,000 watts RMS | ||
THD+N | 0.2% at full rated | ||
power into 8 ohms, 20 Hz - 20 KHz | |||
Frequency Response | ................ | +/- 0.1 dB | |
|
|
| 10 Hz - 22kHz |
Dynamic Range |
| 111 dB | |
Max Input Level |
| 1.5 Vrms | |
Max Output Level |
| 45.5 Vrms | |
Max Gain |
| 30 dB | |
Max Power Consumption | 1600 watts | ||
Input impedance |
| 100 K ohm | |
Input connections | pair each balanced | ||
(XLR) and | |||
Output connections |
| 2 pairs | |
binding posts per channel | |||
Dimensions | 17” W x 9” H x 20” D | ||
Weight |
| 95 lbs |
7