PS Audio C-100, P-200 manual What speakers can I use? What voltages can the Trio run on?

®

Questions And Answers

Owner’s Reference P-200 Preamplifier C-100 Control Amplifier

What speakers can I use?

What voltages can the Trio run on?

You can power nearly every loudspeaker made with a C-100. It is relatively tolerant of most loudspeakers loads and will not be damaged by attempting to power heavy loads. If, while playing music, the C-100 continues to go into a protection mode when the music gets loud, it means that the speaker load is probably too diffi cult for the

C-100.

The Trio is specifi c to your country’s voltage. Do not use the Trio on a voltage higher than it is rated for. For instance, do not take a 120 volt rated Trio and attempt to use it in a 230 volt country. Failure to observe this cautionary note will void your warranty and may damage the amplifi er. If you need to operate the Trio at a voltage other than the voltage it was designed for, contact your dealer, distributor or the factory.

Protection circuitry

Does the amp require ventilation?

If the C-100 protection circuitry is activated, the amplifi er will immediately shut off. You need to switch off the rear power switch and then turn it back on to reset the amplifi er’s protection circuitry.

The Trio produces little heat under normal operation so ventilation requirements are typically minimal, but there needs to be some measure of airfl ow for proper opreation.

4826 Sterling Drive, Boulder, CO 80301	Questions and Answers 5
PH: 720.406.8946 service@psaudio.com www.psaudio.com

©2006 PS Audio International Inc. All rights reserved.