Front Panel | DC Trigger |
Power On/Off
Pressing the Power button will toggle the unit from standby mode to operate mode. When in operation mode the Director will output AC power to any of the three zones that are set to the delayed (DL) or switched (SW) position on the rear panel. The front panel logo will illumi- nate when the Director is on.
The Power Director 3.5 will indicate protection circuitry failure. In this condition the front panel logo will blink and no power will be provided from the rear panel outlets regardless of the position of the power mode switches. If this situ- ation persists contact service at PS Audio.
Note: any zone whose corresponding rear panel switch is in the “ON” position will continue to pass power and provide surge protection even if the director is in standby mode.
The DC input trigger
The trigger will respond to DC voltage over the range of 6 - 18 Volts. The Director will be on when voltage is present and will switch off when the voltage is removed.
Logo trim tool
The Logo trim tool is used to adjust the potenti- ometer which controls the illumination intensity of the PS logo.
Locate the hole in the bottom of the Director. It is directly below the PS logo. Insert the Logo trim tool. Twist clockwise to increase the illumi- nation of the PS logo. Twist
5