SPECIFICATION FOR DOMESTIC WATER HEATERS
Power Combustion,
Furnish and install the following MAXIM gas water heater(s) as manufactured by PVI INDUSTRIES, INC of Fort Worth, Texas.
| Model |
| Btu/h |
| GPH Recovery | Storage |
|
Qty | Number |
| Input |
| 40° to _____°F | Tank Size |
|
___ | ____________ | __________ | ________ | _______ gallons | |||
___ | ____________ | __________ | ________ | _______ gallons | |||
___ | ____________ | __________ | ________ | _______ gallons | |||
|
| Gas and Electrical Consumption |
|
| |||
The water heater will operate at 83% thermal efficiency. |
|
|
|
| |||
Each water heater will have a burner motor with the following maximum electrical ratings: |
| ||||||
Heater Model Number | Heater Btu/h Input | Motor Horsepower | Voltage | Amps | |||
______________ | ___________ | _____ |
| _____ | ____ | ||
______________ | ___________ | _____ |
| _____ | ____ | ||
______________ | ___________ | _____ |
| _____ | ____ |
To conserve energy, the water heater will not utilize a continuously operating, integral circulation pump between the storage and heating section.
Pressure Vessel and Heating Surfaces
The water heater will be a vertical fire tube design that is constructed and stamped in accordance with Section IV, Part HLW of the ASME code. Both the storage and heating sections of the water heater will be National Board Registered for a working pressure of 150 psi and will be pressure tested at
(continued)
PV 1017b 5/99 | 1 |