To Replace Regulator
1.Release all air pressure from air tank. See "To Drain Tank" in the "Maintenance" section.
2.Set the On/Auto/Off lever to "Off" and unplug unit.
3.Using an adjustable wrench remove the outlet pressure gauge and quick connect from the regulator.
4.Using an adjustable wrench remove pressure relief tube.
Outlet
Pressure
Gauge
Quick
Connect
Regulator
Pressure
Relief
Tube
5.Remove the regulator.
6.Apply pipe sealant tape to the nipple on the standpipe.
7.Assemble the regulator and orient as shown.
NOTE: Arrow indicates flow of air. Make sure it is pointing in the direction of air flow.
Nipple
Regulator
Regulator
Arrow
8.Reapply pipe sealant to outlet pressure gauge and quick connect.
9.Reassemble outlet pressure gauge, pressure relief tube and quick connect. Orient outlet pressure gauge to read correctly. Tighten quick connect with wrench.
A10244 | 16- ENG |
