CH00 795.2MHz 00dB AF
PARTS DESCRIPTION
1.Power Switch: Turn on power switch, the display of LCD will illuminate.
2.Power LED indicator: Turn on power switch, this indicator will illuminate.
3.SET: Press once to adjust frequency by UP/DOWN buttons. Press again to exit.
4.UP: Channel UP
5.DOWN: Channel DOWN
6.LCD Display
7.Volume control
8.Antenna A and B
9.Balanced output
10.Unbalanced output
11.12V DC IN
OPERATION
1.Connect the antennas A and B. Make sure they are vertical.
2.Insert one end of included audio cable into "AF OUT" on rear panel, and the other end into "LINE IN" of amplifier or mixer.
3.Connect the power adaptor from DC 12V of receiver to a main power socket.
4.Switch on the receiver. The power indicator comes on. LCD display will illuminate. Press SET once, there will be a mark 
displayed on LCD panel. Now you can adjust frequency by UP/DOWN buttons. Press SET again to exit. Make sure the microphone and receiver to be of same frequency.
5.Switch on the microphone. A letter "A" or "B" will appear in the top right of the LCD, indicating the diversity reception. RF strength (in dB) is indicated in the bottom left corner of the display. When you speak into the microphone, AF signal will display on the bottom of LCD display panel.
3
