PYLE Audio PHRM22

NOTE

- When you walk or run for around 10 seconds, the unit sensor will pick this up and a display

showing current pace for the walk or run will appear.

- If you wish to have the most accurate fitness index calculated by the unit, the user must

use the calibration feature for both walking and running. They will also need to input their

personal user settings

- Your watch is designed to count your steps when it is worn on your left hand. It will not count

your steps correctly if you wear it on your right wrist or on your belt, or if you have it in your

bag.

In order to maximize the accuracy of the step counting feature of the

watch, please wear the watch properly as shown in the diagram

(strap of the watch must fasten tightly around the wrist and it must

not be loose; display must also be perpendicular to the forearm and

wrist; the watch must only be worn on the left wrist and not the right

to maximize the accuracy of step counting) The design and accuracy

of the watch for step counting is based on the positioning of the watch.

The 3D sensor of the watch will automatically count the steps. By

wearing the watch correctly, the steps counted during the daily walk

and, or run will be more accurate.

Please take off the strap from your wrist before you take out the watch

unit.

Low battery detection

Chime

LAP Lap No.

ZONE Heart rate zone select 1/2/3

Kmi/h Kilometer or mile per hour

Heart rate detection

MAX Maximum

Avg Average

Min Minimum

Memory record

/min Heart beat per minute

Alarm 1 or 2

CAL Calories alert on

9FAT Unit of fat burnt

Kcal Unit of calories burnt

Step Step you have walk

AM Time from 0:00.00 to 11:59.59

PM Time from 12:00.00 to 23:59.59

USING THE USB CONNECTOR

- When sliding the USB connector in and out from beneathe the watch,

please press and slide the USB connector where there is the thumb

slide pivot. Please take care and do not push the USB connector back into place when it is

locked in its extended position otherwise this will permanently damage the USB connector.

Press Down

2 Slide Out

Press Down

2 Slide Back