OPERATION
GENERAL OPERATION
Note: In this product design, there has different sound accompanying with every button pressed and the sound is designed differently according to the customers.
•ON/OFF
Switch on the unit by pressing POWER button (9). When system is on, press POWER button (9) again to turn off the unit.
•SOUND ADJUSTMENT
Press PUSH SELECT button (10) to select audio mode shown in the below sequence.
VOLUME
BASS
TREBLE 
BALANCE
FADER (For Fader Version Only)
By rotating the knob (10) clockwise or
If adjustment has not been done in BAS/TRE/BAL/FAD mode, it is returned to the volume select mode (initial) 5 seconds later.
Note: Only in fader version, fader is effective.
•LOUDNESS
Press the LOU button (3) to loudness function and display will show “LOUD”.
Press it again to release this function.
•DISPLAY
Press the DSP button (15) can switch between frequency or play time display and clock display. To set clock, hold down DSP button (15) until the clock is shown on display then press
TUNE/TRACK/SKIP 
button (17) to change hours or TUNE/TRACK/SKIP 
button (16) to change minutes.
•SELECT MODE
Press the MODE button (6) to choose desired listening mode. (e.g. radio, CDP, CDC, tape, TV or AUX mode)
•MUTE
Press the MUTE button (2) to silence the receiver. Press it again to release the mode.
•LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated functions on the display (7).
•EQUALIZATION
Press EQUALIZER button (12) to select SOUND EFFECT as shown in below sequence:
NORMAL 
CLAS
POP 
JAZZ
Press EQUALIZER button (12) over 1 second, graphic display type will display on the LCD and then press
TUNE/TRACK/SKIP 
button (16) or
TUNE/TRACK/SKIP 
button (17) to select graphic display type as follows:
DNCO1
DNCO2 
DNCO3 
DNCO4 
DNCO5 
•REMOTE SENSOR (OPTIONAL) Point the remote control handset to the remote sensor IR (25).
Press the function keys on the handset to control the system.
•AUXILIARY INPUT
The unit can be connected to a portable audio player through the AUX IN jack (11).
•RESET
RESET button (30) must be activated with either a ball point pen or thin metal object. The RESET button (30) is to be activated for the following reasons:
-Initial installation of the unit when all wiring is completed.
-All the function buttons do not operate.
-Error symbol on the display.
6
