PYLE Audio PLDVD198 Din Front/Rear-Mount, Installation Opening, Installing the unit

INSTALLATION

Notes:

Choose the mounting location where the unit will not interfere with the normal driving function of the driver. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly.

Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause Malfunctions.

Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the Vehicle.

Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden

stop, like an emergency stop.

O

If installation angle exceeds 30 from horizontal, the unit might not give its optimum performance.

30

Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from the heater, or where it would be subject to dust, dirt or excessive vibration.

DIN FRONT/REAR-MOUNT

This unit be can properly installed either from "Front"(conventional DIN Front-mount) or "Rear"(DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). For details, refer to the following illustrated installation methods.

DIN FRONT-MOUNT (Method A)

Installation Opening

This unit can be installed in any

dashboard having an opening as show

below:

53mm

182mm

Installing the unit

Be sure you test all connections first, and

then follow these steps to install the unit.

1.Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal.

2.Disconnect the wire harness and the Antenna.

3.Press the release button on the front panel and remove the control panel

4.(see the steps of “removing the front panel”).

5.Lift the top of the outer trim ring then pull it out to remove it.

The two supplied keys release tabs inside the unit's sleeve so you can remove it. One key is for the right side and the other is for the left side. Insert the keys as far as they will go (with the notches facing up) into the appropriate slots at the middle left and right sides of the unit. Then slide the sleeve off the back of the unit.

Sleeve

L Key

Outer Trim Ring

Front Panel

R Key

6