PYLE Audio PLE702B, PLE755S user manual Features and specifications

features and specifications

LED level display these rows of LEDs display the Amplifier Output Levels. Left and right channels are displayed independently at peak levels.

power indicator LED this LED is illuminated when the unit is properly powered, grounded and the remote power has been turned on.

fader control • in a 4 Speaker system, rotating the knob to the FRONT side increases the level of the front speakers; rotating to the REAR side increase level of the rear speakers. At mid position, both sets of speakers are at maximum level.

•in a 2 Speaker system, the fader control should be rotated to the position which provides highest levels for both sets of speakers.

volume control allows adjustment of sound level for particular program material or source.

equalizer controls this seven-band equalizer gives you control over the output levels at various frequencies.

subwoofer frequency control lets you adjust the subwoofer frequency and crossover point from 40-400 Hz. subwoofer boost control lets you adjust the subwoofer boost level from a 0 to +18 dB increase.

power connections connect to power source as follows:

+12V: Connect a red wire of at least 12 gauge to the car battery or other power source.

GROUND: Connect a black wire of at least 12 gauge to car chassis for ground connection

REMOTE: Connect an orange wire to remote activating (12V DC) wire of car stereo or other head unit.

subwoofer channel outputs RCA cables are used to connect the sub outputs to the subwoofer amplifier inputs. line channel inputs RCA cables are used to connect the front input signal from head unit or other source.

speaker connections the connections are used to power a front and rear speaker systems

	PLE702B
	7-Band Equalizer/Amplifier
	with Subwoofer Crossover and Bass Boost
center frequencies	65 Hz · 150 Hz
	400 Hz · 1.4 KHz
	2.4 KHz · 6 KHz
	15 KHz
subwoofer crossover	40 - 400 Hz
bass boost	0 - +18 dB
amplifier power	30 Watts (RMS) x 4
frequency response	20 - 20 KHz (+/– 1 dB)	5
input level	200 mV
(for 10% THD output)
total harmonic distortion (THD)	< 0.5%
(at 15W output)
speaker impedance	4-8 Ohms
signal-to-noise ratio (S/N)	90 dB
separation	60 dB
current drain	6A maximum
power supply voltage	10-16V DC Neg. Ground

dimensions (W x H x L)

mm160 x 29 x 140

inches 6.3 x 1.1 x 5.5