1
6
4
2 | 7 |
35
(Fig. 2)
Removing the unit
1
1.Dashboard
2.Nut (M5)
3.Spring Washer
4.Tapping Screw with Washer (M5 x 25)
5.Screw
6.Plain Washer
7.Strap
Be sure to use the strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle.
1.Lever
Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers upward and out to makes it possible to remove the unit.
DIN REAR-MOUNT
Installation using the screw holes on the both sides of the unit.
1
2
5
4
3
2
5
Fastening the unit to the factory radio mounting bracket.
1.Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted), and tighten the screws at 2 places on each side.
Use either truss screws (5 x 5mm) or screws (4 x 5mm), depending on the shape of the screw holes in the bracket.
2.Screw
3.Factory Radio Mounting Bracket
4.Dashboard or Console
5.Hook and Screw (Remove this part)
Note: The frame, strap, and
4
