PYLE Audio PMX802M, PMX602M Speaker Jack Left/Right, Send/Return, Tape Input, Rec Output, Fan

B. BACK PANEL SECTION FEATURES

1. SPEAKER JACK (LEFT/RIGHT)

These are 2 conductor 1/4” speaker outputs. Each one is rated at 8 ohm minimum impedance. Total minimum load for the amplifier is 4 ohms. You may connect either 1-4 ohm. 1-8 ohm or 2-8 ohm speaker cabinets. Do not below rated minimum impedance.

2. SEND/RETURN

Using by this jack, you can use stereo 1/4＂jacks connector send internal signal which before power amplifier to external effects processing, after processing return to internal power amplifier.

Or you can use stereo or mono 1/4＂jacks connector send external signal to inner power amplifier .

3.TAPE INPUT

These RCA jacks are for brining in a tape deck, CD play or other line level source. The impedance is 10k ohms .

4. REC OUTPUT

These RCA jacks are for hooking up a tape desk to record from the mixer. Both channel are summed into mono for compatibility. The signals are taken pre-master section, meaning that they are without reverb or the master tone section, and does not include the Tape in signal, The impedance is 1K ohms @ -10dBv.

5. FAN

In order to prevent rising the inside temperature, the inside heat is emitted outside.

6. POWER SWITCH

When you want to operate, turn on it, then the LED will be turned on .

_________________________________________________________- 6 -_________________________________________________